The FP1T34 and PF2T34 flow centers feature the Taco 0034e Plus pump and our 3-way 4-postion 1″ FPT geothermal flush and purge valves. The pump volutes and valves are housed in a powder coated sheet metal cabinet which is injected with closed-cell foam for condensation protection when the ground loop fluid temperature drops below the dew point of the conditioned space. These variable speed flow centers have built-in controls and do not require an external controller. The pumps can be set to run at a precise fixed flow rate by setting the RPM, or can operate in differential pressure mode. This is a good solution when more than one heat pump equipped with zone or modulating valves are installed on a common ground loop and share a flow center. The automatic differential pressure control allows the pumps to speed up when zone valves open and slow down when they close. The 0034e also accepts a 0-10V signal so the flow center can be controlled directly by a heat pump that outputs a 0-10V signal.
| PN | Pump | Speed | Valve | Cabinet/Insulated | # Pumps | Photo |
|---|---|---|---|---|---|---|
| FP1T34 (Submittal) | Taco 0034E Plus | Variable | 3-Way Flush/ISO,BR | Powder Coated Steel / Yes | 1 |  |
| FP2T34 (Submittal) | Taco 0034E Plus (2) | Variable | 3-Way Flush/ISO,BR | Powder Coated Steel / Yes | 2 |  |
Performance Data
| Variable Fixed Speed Mode | 0-10V DC or PWM External Input ** |
 |  |
| Proportional Pressure Mode | Constant Pressure Mode |
 |  |
Additional Info
| Dimensional Data *** | Torque Specs |
 |  |
NOTES:
** Pump operates in between maximum and minimum curves. Intermediate curves are
provided for reference.
*** Dimensional data provided for informational purposes and is rounded to nearest
1/16“. Metric data is a simple conversion of imperial data and should not be considered
more accurate.